Contour Design Shuttle-Xpress NLE Multimedia Controller (Black) - Manual (Page 44)

Appendix 1: Example on how to program Global Settings
Below are the steps needed to program Global Settings on the ShuttlePRO v2 by performing the
following associations:
• Command+Q (close the current window) to the Button 13,
• scroll up and down to the jog directions and
• the left and right arrows to the Shuttle positions by varying the frequency.
Step 1
1. Open the Contour Shuttle Control Panel.
2. Click on the Application Setting Menu and select Global Settings.
Step 2: programming Button 13 (Bottom Right Button)
3. Select the Button 13 (Bottom Right Button) in the User Action Menu.
4. Select Type Keystroke from the Computer Response Menu.
5. Click in the Keystroke field then press the Command key and the Q key. “cmd-q” should
appear in the Keystroke field.
6. Click on the Comment field; write “Close the current window” and click OK.
Step 3: programming the Jog directions
7. Select Turn Jog left in the User Action Menu.
8. Select Scroll Up from the Computer Response Menu.
9. Select 3 lines in the Scroll Amount Menu.
10. Select Once Only in the Frequency Menu.
11. Click on the Comment field; write “Scroll 3 lines up” and click OK.
12. Select
Turn Jog right in the User Action Menu.
13. Select Scroll Down from the Computer Response Menu.
14. Select 3 lines in the Scroll Amount Menu.
15. Select Once Only in the Frequency Menu.
16. Click on the Comment field; write “Scroll 3 lines down” and click OK.
Step 4: programming the Shuttle positions
Step 4.1 - left positions
17. Select
Shuttle Zone -1 in the User Action Menu.
18. Select Type Keystroke from the Computer Response Menu.
19. Click in the Keystroke field then press the left arrow on the keyboard. “left” should appear
in the Keystroke field.
20. Select 4 Times per Second in the Frequency Menu.
21. Click on the Comment field; write “Left Arrow - 4 t/s” and click OK.
22. Select
Shuttle Zone -2 in the User Action Menu.
23. Select Type Keystroke from the Computer Response Menu.
24. Click in the Keystroke field then press the left arrow on the keyboard. “left” should appear
in the Keystroke field.
25. Select 6 Times per Second in the Frequency Menu.
26. Click on the Comment field; write “Left Arrow - 6 t/s” and click OK.
27. Select
Shuttle Zone -3 in the User Action Menu.
28. Select Type Keystroke from the Computer Response Menu.
Contour Shuttle Multimedia Controllers 38