Onkyo TX-NR6100 7.2-Channel Network A/V Receiver - Manual (Page 116)

116
Setup Setup
3. Audio Adjust 3. Audio Adjust
„
1. Multiplex/Mono
Change the settings of multiplex audio playback.
‰ Multiplex Input Channel (Default Value: Main)
Set the audio channel or language to be output when playing multiplex audio or
multilingual broadcasts, etc.
• For multiplex audio broadcasts, pressing the button on the remote
controller will display "1+1" on the main unit’s display.
Main Main channel only
Sub Sub channel only
Main / Sub Main and sub channels will be output at the same time.
‰ Mono Input Channel (Default Value: Left + Right)
Set the input channel when playing in Mono listening mode digital signals such
as Dolby Digital or analog/PCM signals recorded in 2 channels.
Left Left channel only
Right Right channel only
Left + Right Left and right channels
‰ Mono Output Speaker (Default Value: Center)
Set the speaker to output monaural audio in the Mono listening mode.
• If an item cannot be selected even though connection is correct, check that
the settings in "2. Speaker" - "Configuration" - "Speaker Channels" matches
the number of connected channels.
Center Audio is output from the center speaker.
Left / Right Audio is output from the front L/R speakers.
„
2. Dolby
Change the setting of when Dolby signals are input.
‰ Loudness Management (Default Value: On)
When playing Dolby TrueHD, enable the dialog normalization function which
keeps the volume of dialog at a certain level. Note that when this setting is Off,
the Late Night function that allows you to enjoy surround at low volumes is fixed
to off when playing Dolby Digital Plus/Dolby TrueHD.
On When this function is used
Off When this function is not used
„
3. DTS
Change the setting of when DTS signals are input.
‰ DTS Auto Surround (Default Value: On)
When inputting DTS signals that include extended channel information, the
optimum listening mode is automatically selected according to the extended
information contained in the input signal and the speaker configuration of this
unit when playing in the straight decoding listening mode.
On When this function is used
Off Audio is played using the same amount of channels in the
input signal according to the speaker configuration of this unit.
• If this function is set to "Off", the ES Matrix and ES Discrete
listening modes cannot be selected.
‰ Dialog Control (Default Value: 0 dB)
You can increase the volume of dialog portion of the audio up to 6 dB by 1 dB
step so that you can hear the dialog easily in noisy atmosphere.
• This cannot be set for content other than DTS:X.
• Depending on the content, this function may not be selected.