Onkyo TX-NR6100 7.2-Channel Network A/V Receiver - Manual (Page 14)

14
Rear Panel
9. GND terminal : Connect the ground wire of the
turntable.
10. AUDIO IN jacks : Input AV component audio
signals with an analog audio cable.
11. ZONE 2 LINE OUT jacks : Output audio signals
with an analog audio cable connected to an
integrated amplifier in a separate room (ZONE
2).
ZONE B LINE OUT jacks : Simultaneously
output the same audio source as the speakers
(ZONE A) connected to this unit by connecting
this unit to wireless headphones, wireless
speaker transmitter, etc., using an analog audio
cable.
PRE OUT FRONT jacks
(European, Australian and
Asian models): Connect to a
power amplifier. ( →p49 )
12. SUBWOOFER PRE OUT jacks : Connect a
powered subwoofer with a subwoofer cable.
Up to two powered subwoofers can be
connected. The same signal is output from each
SUBWOOFER PRE OUT jack.
13. SPEAKERS terminals : Connect speakers with
speaker cables. (North American models support
banana plugs. Use a plug 4 mm in diameter. Y
plug connection is not supported.)
Ú For North American and Taiwanese models
only.
PRE OUT
FRONT
LINE OUT
ZONE 2
ZONE B