Onkyo TX-NR6100 7.2-Channel Network A/V Receiver - Manual (Page 168)

168
Appendix
General Specifications
Amplifier Section
North American and
Taiwanese models
European models Australian and Asian models
Rated Output Power
( North American models)
With 8 ohm loads, both channels
driven, from 20-20,000 Hz; rated
100 watts per channel minimum
RMS power, with no more than
0.08% total harmonic distortion from
250 milliwatts to rated output. (FTC)
( Taiwanese models)
7 ch × 165 W at 6 ohms, 1 kHz, 1 ch
driven of 1% THD (IEC)
7 ch × 165 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC)
Maximum Effective Output Power
( North American models)
210 W at 6 ohms, 1 kHz, 1 ch driven
of 10% THD
( Taiwanese models)
7ch × 175 W at 6 ohms, 1 kHz, 1 ch
driven of 10% THD (JEITA)
175 W at 6 ohms, 1 kHz, 1 ch driven
of 10% THD (JEITA)
7ch × 175 W at 6 ohms, 1 kHz, 1 ch
driven of 10% THD (JEITA)
Dynamic Power (IEC60268-Short-term
maximum output power)
240 W (3 Ω, Front), 210 W (4 Ω, Front), 120 W (8 Ω, Front)
THD+N (Total Harmonic Distortion + Noise) 0.08% (20 Hz - 20,000 Hz, Rated output power)
Input Sensitivity and Impedance 200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM)
Rated RCA Output Level and Impedance
PRE OUT (SUBWOOFER) : 1 V/470 Ω
LINE OUT (ZONE 2/ZONE B) :
200 mV/2.2 kΩ
LINE OUT (ZONE 2/ZONE B)(*) : 200 mV/470 Ω
*1 V/470 Ω if changed to PRE OUT (FRONT)
Phono Maximum Input Signal Voltage 70 mV (MM 1 kHz 0.5%)
Frequency Response 10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Audio)
Tone Control Characteristics ±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE)