Onkyo TX-NR6100 7.2-Channel Network A/V Receiver - Manual (Page 75)

75
Playback
„
Room EQ
It cannot be set if the listening mode is Pure Audio or Direct.
AccuEQ: Enable or disable the equalizer function that corrects for sound
distortion caused by the acoustic environment of the room.
On (All Ch): EQ that corrects according to the room acoustics acquired with the
AccuEQ calibration is applied to all channels.
On (ex. L/R): The same EQ as "On (All Ch)" is applied to speakers other than the
Front Speakers. EQ correction for the Front Speakers is turned off.
• The setting can be separately set to each input selector.
Manual Equalizer: Select "Preset 1" to "Preset 3" configured in "2. Speaker"
- "Equalizer Settings" on the Setup menu. When this is set to "Off", the same
sound field setting is applied to all ranges.
Re-EQ, Re-EQ(THX): Adjusts the soundtrack with the enhanced high range so
that it suits a home theater.
The following listening modes can be used for Re-EQ: Dolby Audio - DD, Dolby
Audio - DD+, Dolby Audio - Surr, Dolby Audio - TrueHD, Multichannel, DTS,
DTS-ES, DTS 96/24, DTS-HD High Resolution Audio, DTS-HD Master Audio,
DTS Neural:X, DTS Express and DSD
In Re-EQ(THX), the following listening modes can be used: THX Cinema and
THX Select Cinema.
„
Level
Front: Adjust the speaker level of the front speakers while listening to the sound.
Center: Adjust the speaker level of the center speaker while listening to the
sound.
Subwoofer: Adjust the speaker level of the subwoofer while listening to the
sound.
• If you set the unit to the standby mode, the adjustments you made will be
restored to the previous statuses.