Epson G10 Series - Manual (Page 20)

Setup & Operation 2. Specifications
10 G10 / G20 Rev.2
2. Specifications
2.1 Features of G10 series and G20 series Manipulators
The G10 series and G20 series Manipulators are high-performance manipulators intended
to achieve high speed, high accuracy, space saving, and high cost-performance.
The G10 series Manipulators are optimized for high speed assembly and alignment
procedure using multiple-hand.
The G20 series Manipulators are optimized for heavy payload transfer and alignment
packing procedure. The 1000 mm long arm model of the G20 series enables wide range
motion.
The features of the G10 series and G20 series Manipulators are as follows:
Compatibility with E2H Manipulators (our existing models)
The installation procedure and mounting dimensions of the end effector are compatible
with those for the E2H Manipulators (our existing models).
Space Saving
Compactness achieved by using a ductless design.
Reduce the system height by the new short stroke (Z: 180 mm) lineup.
Motion Range Extended
The motion range has been extended by 20% compared to E2 series.
Improved Productivity
The numbers of user wires and pneumatic tubes have been increased.
The speed of Joints #1, 2, 3, and 4 has been enhanced.
Cycle time has been improved.
Increased Load Capacity
The load capacity has been increased to handle greater work load.
G10: Max. 10 kg
G20: Max. 20 kg
Increased Inertia
The available end effector capacity has been enlarged to enable larger multiple-hand
that holds multi-kind and different types of work piece.
Allowable moment of inertia has been enlarged according to the load.
G10: Max. 0.25 kgm
2
G20: Max. 0.45 kgm 2
Various Types Available
Long stroke (Z: 420 mm)
Short stroke (Z: 180 mm)