Husqvarna K3000 Wet - Manual (Page 16)

STARTING AND STOPPING
16 – English
Before starting
K3000 Wet
Water connector
• Connect the water hose to the water supply (A). The
water is switched on and off with the water tap (B).
Starting
• Grip the front handle with the left hand.
• Grip the rear handle with your right hand.
• Press in the power switch lock with your right-hand
thumb and press in the power switch.
• Run the machine unloaded and in a safe manner for
at least 30 seconds.
Stopping
Stop the motor by releasing the power switch.
!
WARNING! Note the following before
starting:
The machine should be connected to an
earthed outlet socket.
Check that the mains voltage
corresponds with that stated on the
rating plate on the machine.
Make sure you have a secure footing and
that the cutting blade cannot touch
anything.
Keep people and animals well away from
the working area.
!
WARNING! The machine (Great Britain
120V) is not equipped with a ground fault
circuit interrupter. The machine must
always be used with an isolating
transformer for protection in case an
electrical fault should occur.
!
WARNING! The cutting blade continues
to rotate for some time after the motor
has stopped.