HP STORAGEWORKS E1200-160 - Manual (Page 115)

Serial/Telnet User Interface
115 Network Storage Router e1200-160
4. In the Device List, to add a listed device to the map, enter the number from
the “Num” column.
If the selected device is already mapped, an error message will appear,
warning the user about adding a duplicate device.
Adding a Map Entry to a SCSI Map
To add a new entry to a SCSI map:
1. In the Edit Map Entries screen, select Add (A).
2. Enter a Target/LUN ID combination.
If the selected Target/LUN is already present in the map, a prompt is
displayed that asks to either confirm the override or enter different address
information.
A device selection list is automatically generated.
Note: Devices cannot be mapped to their native port.
Note: A target ID must be defined in the SCSI Configuration to add devices.
3. In the Device List, to add a device to the map, enter the number from the
“Num” column. If the selected device is already mapped, an error message
will appear, warning about adding a duplicate device.
Note: If a device with LUN = “-‘ is selected, all LUNs for this Target will be added to
the map.
Creating a Map Entry for a Fibre Channel Map
To pre-enter a map entry for devices that are not yet online, select Create (C).
Note: All essential information about the device must be known.
A series of questions is displayed. The questions will vary based on the “current”
map protocol. Required information includes the LUN address, protocol, port,
device name, and device type.