Fitting the loop handle, Assembling and dismantling the two-piece shaft, Assembly – Husqvarna 123LD User Manual

Page 12: Dismantling, Fitting the trimmer guard and trimmer head

Advertising
background image

12 –

English

ASSEMBLY

Fitting the loop handle

•

Position the handle on the shaft. Note that the handle
must be mounted below the arrow on the shaft.

•

Fit the screw, securing plate and wing nut as shown in the
diagram.

•

Tighten the wing nut.

Assembling and dismantling the
two-piece shaft

(123LD)

Assembly:

•

Make sure the knob is loose.

•

Align the cut-out in the lower part of the shaft with the
coupling locking tab on the upper part of the shaft. Then
lock the sections together.

•

Tighten the knob.

Dismantling:

•

Undo the knob (at least three turns).

•

Push the knob towards the coupling.

•

Carefully twist the lower half of the shaft to unlock it.

•

Hold both parts of the shaft and pull the lower part of the
shaft out of the coupling.

Fitting the trimmer guard and
trimmer head

(123L, 123LD)

•

Fit the correct trimmer guard (A) for use with the trimmer
head.

Hook the trimmer guard/combination guard onto the fitting
on the shaft and secure with the bolt (L).

• Fit the drive disc on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.

• Insert the locking pin in the hole to lock the shaft.

•

Screw on the trimmer head/plastic blades (H) in the
opposite direction to the direction of rotation.

•

To dismantle, follow the instructions in the reverse order.

!

WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.

A

H

H

Advertising
This manual is related to the following products: