Hot-plug scsi hard drive options, Scsi ids – HP DL385 User Manual

Page 47

Advertising
background image

Hardware options installation 47

5.

Install the DIMM.

6.

Install the access panel ("

Installing the access panel

" on page

29

).

Hot-plug SCSI hard drive options

When adding SCSI hard drives to the server, observe the following general guidelines:

•

A maximum of 14 SCSI devices per channel can be added.

•

Each SCSI drive must have a unique ID. The system automatically sets all SCSI IDs.

•

The SCSI ID for each hot-plug hard drive is set automatically to the next sequential ID number in a

series beginning with ID0.

•

If only one SCSI hard drive is used, install it in the bay with the lowest number.

•

Hot-plug hard drives must be either Wide Ultra2, Ultra3, or Ultra320 SCSI types. Mixing these types

with other drive standards degrades the overall performance of the drive subsystem.

•

Drives must be the same capacity to provide the greatest storage space efficiency when drives are

grouped together into the same drive array.

SCSI IDs

The server supports single- or dual-channel hard drive configurations. The single-channel configuration

(simplex) supports up to six hard drives on one channel. The dual-channel configuration (duplex) supports

two hard drives on one channel (SCSI IDs 0 and 1) and up to four hard drives on the other channel (SCSI

IDs 2 through 5).

Advertising
This manual is related to the following products: