Hot-plug tape drive option – HP DL385 User Manual
Page 53
Advertising
Hardware options installation 53
7.
Secure the diskette drive cable to the diskette drive cable connector on the SCSI backplane board or
SAS backplane board.
8.
9.
Power up the server (on page
Hot-plug tape drive option
NOTE: This feature applies only to SCSI models.
1.
Remove the existing hard drive blank or hard drive from the upper-left drive bay.
2.
Reach underneath and squeeze the middle of the tape drive blank (1).
3.
Pull the blank out of the bay (2).
Advertising
This manual is related to the following products: