Hifionics BRE100.2 - Manual (Page 5)

3
BRE100.2 2-CHANNEL AMPLIFIER APPLICATIONS
POWER INPUT
GND REM BA
TT+12V
SPEAKER OUTPUT RIGHT LEFT - + - +
BRIDGED
FUSE
HP
FULL
LP/BP
10Hz 15KHz
30Hz 150Hz
0dB 10dB
6V 0.2V
REMOTE
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
POWER
X-OVER
PROTECT
LINE INPUT L R
L R
LINE OUT
POWER INPUT
GND REM BA
TT+12V
SPEAKER OUTPUT RIGHT LEFT - + - +
BRIDGED
FUSE
HP
FULL
LP/BP
10Hz 15KHz
30Hz 150Hz
0dB 10dB
6V 0.2V
REMOTE
HI P
ASS
LOW P
ASS
BASS EQ
LEVEL
POWER
X-OVER
PROTECT
LINE INPUT L R
L R
LINE OUT
4. Line Level: This is the most basic application for the ELITE Series 2 channel amplifiers.
Refer to the section “Setting up systems after installation for best performance”
1. Interconnect cable checklist:
Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.
NOTE: Minimum final loudspeaker impedances:
2. Crossover Switch: 4 & 2 Ohms stereo mode or 4-Ohms mono mode
The X-OVER switch must be in the FULL position. This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono operation.
3. Crossover frequency control checklist:
N/A for full range operation.
FULL RANGE STEREO
MONO
Switch setting checklist: This application illustrates the basic mono bridging method for all Hifonics
- The AMPLIFIER X-OVER switch should be in the LP/BP position. amplifiers.
Crossover frequency control setting checklist: Interconnect cable checklist:
LPF: 11 o’clock A MONO signal source is required, such as would be available from the mono
sub bass output of an active crossover, whether stand alone, or built into a head
Minimum final loudspeaker impedance: unit or equalizer. Important: Do not be tempted to connect the hot, or positive
outputs, from any source together to obtain a mono signal, as this could very
- 4 ohm mono.
well damage the output stage of that source.
It is necessary to feed the SAME signal to both left and right inputs via a Y-
adapter RCA cable. Connect the mono speaker positive terminal to the LEFT +,
and its negative terminal to RIGHT -.
FULL RANGE
STEREO LINE INPUT
REMOTE TURN-ON
REMOTE TURN-ON
CHASSIS GROUND
CHASSIS GROUND
TO BATTERY +12v
VIA FUSE
TO BATTERY +12v
VIA FUSE
FULL RANGE
SPEAKERS
FULL RANGE
MONO LINE INPUT
VIA Y-ADAPTER
FROM MONO SOURCE
MONO SPEAKER
or SUBWOOFER
BRUTUS
ELITE
BRUTUS
ELITE