Removing a sdram module, Removing a sdram module -5, Figure 2-3. removing an sdram module -5 – HP Pavilion ze5300 User Manual
Page 76: User-replaceable)
Removing a SDRAM Module
(User-Replaceable)
The notebook has no system memory built into its motherboard, but has two slots for SDRAM
modules. One slot contains an SDRAM module that was factory installed.
Note
HP Pavilion ze5300, ze5200, ze4300, ze4200, and ze4100, HP nx9010, nx9005 and nx9000,
Compaq Evo Notebook N1050v and N1010v, and Presario 2500, 2100, and 1100 notebooks use
only DDR266 SDRAM modules. Using the wrong type of module prevents the notebook from
booting.
Caution
Handle the SDRAM module only by its edges and provide proper grounding, or you might damage
the module through electrostatic discharge.
Required Equipment
• #1 Phillips screwdriver.
Removal Procedure
1.
2.
3.
4.
Unplug the AC adapter, if present, and then remove the battery.
On the bottom of the notebook, loosen the captive screws holding the SDRAM door, and then
remove the door.
Press outward on the latches at the sides of the SDRAM module to release it (the SDRAM module
pops up).
Carefully pull the SDRAM module out of the connector.
Figure 2-3. Removing an SDRAM Module
HP Pavilion 4300, 4200, and 4100, HP nx9005 and nx9000,
Compaq Evo Notebook N1050 and 1010, and Compaq Presario 2100 and 1100 Models
Service Manual
Removal and Replacement
2-5