Husqvarna 532 42 89-49 - Manual (Page 6)

6
Fig. 5
02 05 1
A
NOTE: Be su re mower side suspension arms (A) are pointing
forward before sliding mower under tractor.
• Slide mower under tractor until it is centered under
tractor.
TO INSTALL MOWER (See Figs. 4-12)
Be sure tractor is on level surface and engage park ing brake.
• Lower attachment lift lever to it's lowest position.
CAUTION: Lift lever is spring loaded.
Have a tight grip on lift lever, lower it
slowly and engage in lowest position.
02965
Fig. 4
ASSEMBLE FRONT WHEEL TO MOWER
(See Fig. 3)
• Using shoulder bolt, washer and locknut from parts
bag, as sem ble front wheel to mower as shown. Tighten
securely.
Fig. 3
• Turn steering wheel to the left as far as it will go and
position mower on right side of tractor with deflector
shield to the right.
NOTE: You may now roll your tractor off the skid. Follow the
instructions below to remove the tractor from the skid.
WARNING: Before start ing, read, un der stand and fol low
all in struc tions in the Op er a tion section of this man u al. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other peo ple and objects.
TO ROLL TRACTOR OFF SKID (See Op er a tion
section for location and function of con trols)
• Raise attachment lift lever to its highest po si tion.
•
Release parking brake by de press ing clutch/brake ped al.
• Place freewheel control in "trans mis sion dis en gaged"
position (See “TO TRANS PORT” in the Op er a tion
section of this manual).
• Roll tractor forward off skid.
Continue with the instructions that follow.
TO ADJUST SEAT (See Fig. 2):
• Grasp adjustment handle(A) and pull up, slide seat to
desired po si tion and release adjustment handle.
A
Fig. 2
• FIRST INSTALL ANTI-SWAY BAR (S).
• From right side of mower, insert anti-sway bar into
hole in transmission bracket (T).
Fig. 6
S
T
A
ASSEMBLY