HONDA TL6552 - Manual (Page 10)

DEALER CHECK LISTS
PRE-DELIVERY CHECK LIST
lnspect the Rotary Tiller thoroughly after assembly
to be certain it is set up properly before delivering
it to the customer. The following checklist is a
reminder of points to inspect. Check off each item
as it is found to be satisfactory or after proper
adjustment is made.
- Check all bolts to be sure they are tight.
- Check that all cotter pins are properly
- Check that all lubrication points with
grease fittings have been lubricated.
- Check that tines have been properly
installed.
- Check gear box oil level.
- Verify safety labels are applied and are
installed.
in good condition.
DELIVERY CHECK LIST
- Show customer how to make
adjustments.
- Explain importance of lubrication to
customer and point out lubrication
points on tiller.
- Give this Operator's Manual to the
customer and ask customer to become
familiar with all sections of it.
ATTACHING THE TILLER TO THE
Ensure the tractor has been
prepared as instructed under TRACTOR
PREPARATION section of this manual to
prevent serious personal injury or equipment
damage.
1 Attach the lower lift arms of the three point hitch
and secure with clips as shown in Fig. 11.
2 Install the hitch top link to the tractor mounting
bracket and secure with clip as shown in Fig.
13.
3 Install the other end of the hitch top link to the
tiller and secure with clip as shown in Fig. 15.
4 Adjust the right hand hitch lift rod to make the
tiller parallel with the ground (left to right) when
the tiller is raised slightly off the ground.
Shortening the lift rod will raise the right side of
the tiller, lengthening the lift rod will lower the
right side of the tiller. Fig. 12
5 Adjust the hitch top link to make tiller parallel with
the ground (front to rear). Increasing the length
of the top link will cause the rear of the tiller to
drop, shortening the link will cause the rear of
the tiller to raise. Tighten the locking nut on the
top link securely. Fig. 15
6 Position the tiller to sit approximately in the center
of the rear wheels and adjust the stabilizer
check links to prevent excessive left to right
sway.
Fig. 14
7 Attach the tiller driveline onto the tractor PTO
shaft, making sure it has locked into the groove
of the shaft.
- Move the driveline back and forth to
ensure it is securely connected.
Do not operate the tiller without the driveline
shields in place and in good condition. Operating
the tiller without
shields in place could result in
severe personal injury or death.
Before operating, raise and lower the tiller slowly
through its full range with the three point hitch to
ensure the driveline does not bottom out or come
apart.
8
I
TRACTOR