HONDA TL6552 - Manual (Page 16)

SLIP CLUTCH ADJUSTMENT
The slip clutch is factory preset to the correct torque
for protecting implement and tractor, and should
seldom require adjusting. Should adjustment be
needed, first check to be sure all spring lengths are
within 1/16" (1.6 mm). If necessary loosen nuts on
any springs that are unequal. Adjust all eight spring
retaining nuts 2/3 of a
turn (4 flats on nut) and check
clutch slippage. If farther adjustment is necessary,
adjust in 1/3 turn increments or consult your HONDA
Compact Tractor Dealer. Adjust only to provide
sufficient torque to prevent slippage under normal
conditions. When rocks, roots, etc., are present,
occasional slippage is normal for drivetrain
protection.
SPECIFICATIONS
Approximate Working Width .................................................................................................................. 52"
Inside Housing Width ............................................................................................................................... 51"
'
Input RPM ................................................................................................................................................. 540
Required P.T.O. HP Range ................................................................................................................... 11- 40
Type Hitch ................................................................................................................................ 3-point Cat. I
Rotor Shaft Speed ........................................................................................................................... 220 RPM
Gearbox rations ..................................................................................................................... Input - 1.461: 1
Lateral - 1.687 : 1
Deck Material .................................................................................................................................. 1/8" steel
Tilling Depth ....................................................................................................................................... 0" - 5"
No. of Blades .............................................................................................................................................. 32
Implement Weight ............................................................................................................................. 341 lbs.
Shipping Weight ................................................................................................................................. 390 lbs.
14