HONDA TL6552 - Manual (Page 8)

DEALER ASSEMBLY
INSTRUCTIONS
Install the driveline safety clutch onto the
tiller input shaft and tighten the retaining bolt.
Fig. 5.
Attach three point hitch mast struts and
driveline shield to tiller frame using M12x30
mm. bolts, lock washers and nuts. Fig.2.
Attach mast braces to mast struts using a
M12x90mm bolt, spacer, nut and jam nut.
Fig. 3.
Secure mast brackets onto clamps on gearbox
housing using a M12x80mm spacer, nut and
jam nut.
Install hitch pin brackets onto frame using two
M12x90mm bolts, with lock washers. Fig.
6.
Brackets must be installed with the weld nut
on top side maintaining a distance of 26"
(660 mm) centered between brackets. Fig. 7.
Check gearbox oil level per instructions in
LUBRICATION section.
Make certain all safety shields and safety
labels are in place and in good condition.
Check the tiller tine bolts to ensure they are
tight.
Torque to 73 ft. Ibs. (10.1 Km) Fig. 4 .
Apply a coating of grease to the telescoping
parts of the driveline Fig. 9.
10 Using a grease gun and a multi-purpose
grease, ensure the tiller tine shaft and the
driveline are lubricated Fig. 8
11 Position the hitch pin brackets as shown and
tighten the bolts securely. Fig. 7.
12 Set preliminary adjustment of hitch top link to
22 inches (560 mm) as shown. Fig. 10.
6