Honeywell HJZTP - Manual (Page 24)

Rev. 1.01 14 900.0570
8-Sept-05
3.3.2 DVR/Multiplexer/Camera Connection
Note: The DVR/multiplexer/camera connection can only be set from the master
keyboard. The DVR/MUX menu can be viewed on a slave keyboard, but ‘AUX = SET’
will not be displayed, and no editing will be allowed. To ensure slave keyboards have the
correct DVR/multiplexer/camera connection configuration, they must be set as slave
keyboards, and connected to the master keyboard before editing the configuration on
the master keyboard. Alternately, entering and exiting the DVR/MUX menu on the master
keyboard, or powering up the master keyboard, will resend the configuration to the slave
keyboards.
By default the keyboard it is set to control eight 16-way DVRs, and eight 16-way
multiplexers. With cameras 1 to 16 connected to DVR 1 and multiplexer 1, cameras 17 to
32 connected to DVR 2 and multiplexer 2, etc., up to cameras 113 to 128 connected to
DVR 8 and multiplexer 8.
The keyboard can control 1, 4, 9 and 16-way DVRs and/or 4, 9, 16-way multiplexers
To set the DVR/multiplexer/camera connection, select ‘DVR / MUX’ in the keyboard
setup menu. The following menu will be displayed:
A U X = S E T L O C K = E N D
C A M 1 D V R 1 M U X 1
The menu shows that camera 1 is connected to DVR 1 and Multiplexer 1. The number ‘1’
next to ‘DVR’ will be flashing indicating that this number will be edited by pressing the
‘aux’ key.
Use the joystick up and down or the ‘F1’ (‘’) and ’F2’ (‘’) keys, to scroll through all
128 cameras.
Use the joystick left and right or the ‘F3’ (‘’) and ‘F4’ (‘’) keys (or ‘camera’ and
‘preset’ keys) to select the DVR or MUX number.
Pressing the ‘aux’ key will cycle through all legal settings of the selected DVR or
multiplexer number. ‘NO’, indicates no DVR or no multiplexer is connected to the
camera.
The menu only allows cameras be assigned to DVRs in blocks of 1, 4, 9 or 16, or to
Multiplexers in blocks of 4, 9 or 16, to correspond with 1, 4, 9 or 16-way
DVRs/Multiplexers. If ‘AUX = SET’ is not displayed, then there are no legal alternatives to
the number already displayed, and so the number cannot be edited.