Honeywell HJZTP - Manual (Page 36)

Rev. 1.01 26 900.0570
8-Sept-05
HONEYWELL VCL PROTOCOL, CONTINUED
6.5 ZOOM
Rotate the top of the joystick clockwise to zoom in.
Rotate the top of the joystick counter-clockwise to zoom out.
6.6 FOCUS AND IRIS
Press the auto key above the focus control keys to toggle the camera in and out of ‘auto-
focus’ mode, if the feature is available on the selected camera/receiver.
Press the ‘+’ (FAR) or ‘-’ (NEAR) keys to manually focus the camera. (The camera
automatically changes to ‘manual focus’ mode if one of these two keys is pressed.)
Press the auto key above the iris control key to toggle the camera in and out of ‘auto-iris’
mode, if the feature is available on the selected camera / receiver. Press the ‘+’ (OPEN)
or ‘-’ (CLOSE) keys to manually alter the camera iris. (The camera automatically changes
to ‘manual iris’ mode if one of these two keys are pressed.)
6.7 WASH, WIPE AND AUXILIARY FUNCTIONS
If the receiver being controlled has WASH and WIPE functions, they are controlled as
follows:
FOR WIPE.
Press the ‘wipe’ key to activate the wiper.
Press the ‘wipe’ key again to turn off the wiper.
FOR WASH.
Press and hold the ‘wash’ key to activate the washer.
Release the ‘wash’ key to turn off the washer.
If the receiver has a separate momentary function (auxiliary), it is controlled as follows:
Press the ‘0’ key, then press and hold the ‘aux’ key to activate the auxiliary function.
Release the ‘aux’ key to turn off the auxiliary function.
Note: The ‘aux’ key illumination is not altered by this operation as it is used to monitor
‘Change Over’ RapidDome/Orbiter domes.