Husqvarna 327HDA65X - Manual (Page 11)

ASSEMBLY
English – 11
Adjusting the harness
(327HE4)
You should always use the harness with the machine to
give maximum control over the machine and reduce the
risk of fatigue in your arms and back.
1 Put on the harness.
2 Hook the machine onto the harness support hook.
3 Adjust the length of the harness so that the support
hook is roughly level with your right hip.
Fitting the impact guard
(327HE4)
Fit the guard using the three screws and washers. Fit the
two short screws in hole A. Tighten the screws to a torque
of 4 Nm. After the machine has been in use for around 20
hours, re-tighten the screws to 4 Nm.