Husqvarna 16 AWD - Manual (Page 21)

English – 21
Maintenance
Cleaning
Clean the machine directly after use. It is much easier to wash
off grass cuttings before they dry.
Oily dirt can be removed using a cold degreasing agent.
Spray on a thin layer.
Rinse at normal water pressure.
Do not direct the jet towards electrical components or
bearings.
Do not rinse hot surfaces such as the engine and exhaust
system.
Put the cutting unit in the service position first. Hose down the
cutting unit with water underneath each time it is used.
It is recommended that you start the engine and run the
mower for a short period after cleaning, so that any remaining
water is blown off.
Lubricate the machine if necessary after cleaning. Carry out
extra lubrication when the bearings have been exposed to a
degreaser or a water jet.
There is a major risk of water penetrating into bearings and
electrical connections. Corrosion attack can result, which will
lead to running problems. Cleaning additives generally
aggravate the damage.
Removing of the machine hoods
Engine cover
The engine becomes accessible for service when the engine
cover is opened.
Fold the seat forward, loosen the rubber strap under seat and
fold the cover backwards.
Front cover
Release the clip on the front hood and lift off the fender.
Right-hand fender
Remove the screws holding the wing cover (2 and 3). The
knob (1) should also be removed on Rider 13 C, Rider 16
AWD and Rider 16 C.
Left-hand fender
Remove the screws holding the wing cover (2) and lift off the
cover.
IMPORTANT! Avoid using a high pressure washer or a
steam cleaner.