Hardware installation & setup, 1 rear panel & connections – Huawei AOLYNK WDR814IG User Manual
Page 13
Aolynk WDR814(I)g ADSL2+ Wireless Router User Manual
2 Hardware Installation & Setup
10
2
Hardware Installation & Setup
This chapter provides information about your ADSL Wireless Router
’s
physical
features and gives step-by-step installation instructions for hardware installation and
software configuration.
2.1 Rear Panel & Connections
The following figures show the rear view of the ADSL Wireless Router and illustrate
how the cables connect to the interfaces on the rear panel.
Step1 Plug one end of the ADSL line (Standard phone line) into the ADSL port, the other into
the wall jack that is connected to the ADSL service.
Step2 Connect the Ethernet NIC (Network Interface Card) port of a PC to one of the LAN
Ports.
Step3 Connect the external power supply to the ADSL Wireless Router.
Step4 The Reset button is used to reboot and re-initialize the device (press once quickly), or
for clearing configuration settings back to factory default values (press for longer than
3 seconds).
& Note:
If you are Macintosh users, please refer to Chapter 6 Macintosh Setup for more