HP 7200 - Manual (Page 57)

Refer to the following table to determine which paper size to choose based on the
paper loaded in the input tray.
Paper type Suggested paper size settings
Copier, multi-purpose, or plain papers Letter or A4
Inkjet papers Letter or A4
Iron-on transfers Letter or A4
Letterhead Letter or A4
Photo papers 10 x 15 cm or 10 x 15 cm Borderless
13 x 18 cm or 13 x 18 cm Borderless
4 x 6 inches or 4 x 6 Borderless
5 x 7 inches or 5 x 7 Borderless
Letter or Letter Borderless
A4 or A4 Borderless
L-size or L-size Borderless (Japan only)
Hagaki cards Hagaki or Hagaki Borderless (Japan
only)
Transparency films Letter or A4
Set the copy paper type
You can set the paper type on your HP All-in-One. The default paper type setting for
copying is
Automatic , which causes the HP All-in-One to detect the type of paper in
the input tray.
If you copy onto special papers, or if you experience poor print quality by using the
Automatic setting, you can set the paper type manually from the Copy menu.
1. Make sure you have paper loaded in the input tray.
2. Load your original face down on the right front corner of the glass or face up in
the document feeder tray.
If you use the document feeder tray, place the page so that the top of the
document is inserted first.
3. In the Copy area, press Menu until Copy Paper Type appears.
4. Press to select a paper type setting, and then press OK .
5. Press Start Copy Black or Start Copy Color .
Refer to the following table to determine which paper type setting to choose based on
the paper loaded in the input tray.
Paper type Control panel setting
Copier paper or letterhead Plain Paper
HP Bright White Paper Plain Paper
Chapter 7
54 HP Officejet 7200 All-in-One series
Use
the copy features