HP 7200 - Manual (Page 71)

Note The menus shown in this section might vary in content depending on
the operating system on your computer, and which applications you set up as
scan destinations in the HP Image Zone software.
Scan an original (USB-connected)
Follow these steps if your HP All-in-One is directly connected to a computer through a
USB cable.
1.
Load the original face down on the right front corner of the glass.
2. In the Scan area, press Scan To .
The Scan To menu appears, listing destinations, including applications, for
anything you scan. The default destination is the one you selected the last time
you used this menu. The Scan To menu can be configured. You can designate
which applications and other destinations appear on the Scan To menu by using
the HP Image Zone software on your computer.
3. To select an application to receive the scan, press until the destination you
want displays on the control panel display, and then press
Start Scan .
A preview image of the scan appears in the HP Scan window on the computer,
where you can make changes to the preview before the final scan. Changes
made to the preview image are not saved to the original image file.
For more information about editing a preview image, see the onscreen HP Image
Zone Help that came with your software.
4. Make any edits to the preview image in the HP Scan window. When you have
finished, click Accept.
The HP All-in-One sends the scan to the selected application. For example, if you
chose the HP Image Zone software, it automatically opens and displays the
image.
Scan an original (network-connected)
Follow these steps if your HP All-in-One is connected to one or more computers over
a network.
1.
Load the original face down on the right front corner of the glass.
2. In the Scan area, press Scan To .
The Scan To menu appears, listing various options.
3. Press to highlight Select Computer , and then press OK .
The Select Computer menu appears, listing computers connected to the HP All-
in-One.
Note The Select Computer menu might list computers with a USB
connection in addition to those connected through the network.
4. To select the default computer, press OK . To select another computer, press
to highlight your selection and then press OK . To send the scan to an application
on your computer, choose your computer in the menu.
The Scan To menu appears, listing destinations, including applications, for
anything you scan. The default destination is whichever one you selected the last
time you used this menu. You designate which destinations appear on the Scan
To menu by using the HP Image Zone software on your computer. For more
information, see the onscreen HP Image Zone Help that came with your software.
Chapter 8
68 HP Officejet 7200 All-in-One series
Use the
scan
features