HP 7200 - Manual (Page 88)

Back view of the HP All-in-One
1 Telephone wall jack
2 Phone cord supplied in the box with your HP All-in-One connected to the "1-LINE" port
To set up your HP All-in-One with voice mail
1.
Using the phone cord supplied in the box with your HP All-in-One, connect one
end to your telephone wall jack, then connect the other end to the port labeled "1-
LINE" on the back of your HP All-in-One.
Caution If you do not use the supplied cord to connect from the
telephone wall jack to your HP All-in-One, you might not be able to fax
successfully. This special phone cord is different from the phone cords
you might already have in your home or office. If the supplied phone cord
is too short, see
The phone cord that came with my HP All-in-One is not
long enough for information on extending it.
2. Set up the HP All-in-One to answer incoming calls manually. Press the Auto
Answer button until the light is off.
3. Run a fax test. For information, see Test your fax setup .
You must be available to respond in person to incoming fax calls, or your HP All-in-
One cannot receive faxes. For information on receiving faxes manually, see
Receive a
fax manually .
Case G: Fax line shared with computer modem (no voice
calls received)
If you have a fax line on which you receive no voice calls, and you also have a
computer modem connected on this line, set up your HP All-in-One as described in
this section.
Since your computer modem shares the phone line with your HP All-in-One, you will
not be able to use both your computer modem and your HP All-in-One for faxing
simultaneously. For example, you cannot use your HP All-in-One for faxing if you are
using your computer modem to send an e-mail or access the Internet.
User Guide 85
Fax setup