Husqvarna 325HD60 - Manual (Page 19)

English – 19
MAINTENANCE
Weekly maintenance
1 Check the starter, the starter cord and the recoil spring.
2 Check that the vibration damping elements are not
damaged.
3 Clean the outside of the spark plug. Remove it and check
the electrode gap. Adjust the gap to 0.5 mm or replace the
spark plug. Check that the spark plug is fitted with a
suppressor.
4 Clean the cooling fins on the flywheel.
5 Clean or replace the spark arrestor mesh on the muffler
(only applies to mufflers without a catalytic converter).
6 Clean the carburettor compartment.
7 Clean the cooling fins on the cylinder and check that the
air intake near the starter is not blocked.
8 Fill the gear housing with grease. This should be carried
out approximately every 20 working hours.
9 Clean the air filter.
10 Check that the screws that hold the blades together are
correctly tightened.
Monthly maintenance
1 Clean the fuel tank.
2 Clean the outside of the carburettor and the space around
it.
3 Clean the fan and the area around it.
4 Check the fuel filter and the fuel hose. Replace if
necessary.
5 Check all cables and connections.
6 Check the clutch, clutch springs and the clutch drum for
wear. Replace if necessary.
7 Replace the spark plug. Check that the spark plug is fitted
with a suppressor.
8 Check and clean the spark arrestor mesh on the muffler
(only applies to mufflers fitted with a catalytic converter).
1 2 3
6 5 4
7 8
10
9
7 8 5 4
1 2 3