HONDA HRX217VKAA - Manual (Page 14)

14
2. To drain the fuel tank, turn
the fuel valve ON (page 6).
This will allow fuel in the
fuel tank to drain out
through the carburetor
bowl.
3. After the fuel is completely
drained, reinstall the drain
bolt.
Engine Oil
Change the engine oil (page 10).
Engine Cylinder
1. Remove the spark plug
(page 11).
2. Pour a tablespoon
(5 ~ 10 cc) of clean engine
oil into the cylinder. This will
prevent rust from
developing inside the
engine.
3. Press and hold the blade
control lever, then pull the
starter rope several times to
distribute the oil in the
cylinder.
4. Reinstall the spark plug.
5. Press and hold the blade control lever, then pull the starter rope
slowly until resistance is felt, and then return the starter grip gently.
This will close the valves so moisture cannot enter the engine
cylinder.
Handlebar Folding
The handlebar can be folded for storage or transport by unlocking the
handlebar adjust knobs.
1. Remove the grass
bag. You can place it
on top of the engine,
with the bag opening
to the front.
2. Unlock the handlebar
adjust knobs.
3. Press and hold the
blade control lever.
4. Swing the handlebar
forward. Prevent the
cables from getting pinched or kinked.
When unfolding the handlebar, be sure to lock the adjust knobs to
secure the handlebar in the mowing position.
PLACING IN STORAGE
If your mower will be stored with gasoline in the fuel tank and
carburetor, it is important to reduce the hazard of gasoline vapor
ignition. Select a well-ventilated storage area away from any
appliance that operates with a flame, such as a furnace, water heater,
or clothes dryer. Also avoid any area with a spark-producing electric
motor or where power tools are operated.
If possible, avoid storage areas with high humidity because humidity
promotes rust and corrosion.
Make sure the fuel valve is in the OFF position to reduce the
possibility of fuel leakage.
Place the mower with its wheels on a level surface. Tilting can cause
fuel or oil leakage.
The handlebar can be folded for compact storage.
With the engine and exhaust system cool, cover the mower to keep
out dust. A hot engine and exhaust system can ignite or melt some
materials. Do not use sheet plastic as a dust cover. A nonporous
cover will trap moisture around the mower, promoting rust and
corrosion. Honda recommends using the optional stretch fabric
storage cover (page 17).
REMOVING FROM STORAGE
Check your mower as described in BEFORE OPERATION (page 4).
If the fuel was drained during storage preparation, fill the tank with
fresh gasoline. If you keep a container of gasoline for refueling, be
sure that it contains only fresh gasoline. Gasoline oxidizes and
deteriorates over time, causing hard starting.
If the cylinder was coated with oil during storage preparation, the
engine will smoke briefly at startup. This is normal.
TAKING CARE OF
UNEXPECTED PROBLEMS
Engine Will Not Start
DRAIN BOLT
SPARK
PLUG
HOLE
OIL



Possible Cause Correction
Fuel valve OFF Turn the fuel valve ON (page 6).
Out of fuel Refuel (page 12).
Bad fuel, mower stored
without treating or draining
gasoline, or refueled with bad
gasoline Drain the fuel tank and carburetor
(page 13). Refuel with fresh
gasoline (page 12).
Spark plug faulty, fouled, or
improperly gapped Gap or replace the spark plug
(page 11).
Spark plug wet with fuel
(flooded engine) Dry and reinstall the spark plug.
Fuel filter clogged, carburetor
malfunction, ignition
malfunction, valves stuck,
etc. Take the mower to an authorized
Honda servicing dealer for repair.