Using the appliance, Dry use, Convertible nozzle – Philips FC6841 User Manual

Page 10: Wet use, Vacuuming liquids, Shampooing carpets, Carpet shampooing techniques

Advertising
background image

9

Fasten the long shampoo hose to the suction hose and suction tube with the shampoo hose

clips (Fig. 32).

10

Attach the double-injection nozzle (Fig. 6).

The appliance is now ready for shampooing soft floors, such as carpets and rugs.

using the appliance

1

Pull the mains cord out of the appliance and insert the mains plug into the wall

socket (Fig. 33).

2

Press the motor on/off button to switch on the appliance (Fig. 34).

Dry use
Convertible nozzle

1

You can use the convertible nozzle to vacuum hard and soft floors: (Fig. 35)

- With the brush strip folded out, you can use the nozzle to clean hard floors (wooden, ceramic,

stone and synthetic floors)

- With the brush strip folded in, you can use the nozzle to clean soft floors (carpets and rugs)

Wet use
vacuuming liquids

Note: When you vacuum water from a place that is located higher than the appliance itself (e.g. a roof

gutter or roof water tank), the appliance inevitably functions as a syphon. As a result, the container fills up

more quickly than usual and may overflow. Make sure you never exceed the maximum capacity of the

container (9 litres/2 gallons) (Fig. 36).

To make sure that the container does not overflow when you vacuum liquids, perform the following

procedure at regular intervals:

1

Lift the nozzle out of the water.

2

Press the motor on/off button to switch off the appliance.

3

Remove the mains plug from the wall socket.

4

Empty the container.

shampooing carpets

1

Start as far away from the door as possible and then work your way towards the door.

2

Apply shampoo by squeezing the trigger on the handgrip of the tube (Fig. 37).

3

Make overlapping strokes to cover the entire area to be cleaned.

Note: If there are still traces of liquid on the area you have just cleaned, pass the vacuum cleaner over

this area once more without applying shampoo.

4

After shampooing, release the trigger and switch off the pump. Keep the appliance switched

on (Fig. 38).

5

Lift the nozzle off the floor. Then simply let the appliance suck in dry air for some time to dry

the inside of the suction hose and tube (Fig. 39).

6

Switch off the appliance.

Carpet shampooing techniques

Depending on the degree of soiling, you can use (and combine!) the following three carpet

shampooing techniques.

1 Freshening up

English

10

Advertising
This manual is related to the following products: