Hoshizaki KMD-901MRH - Manual (Page 10)

10
II. Installation and Operating Instructions
A. Checks Before Installation
IMPORTANT
1. Install in accordance with all applicable national, state, and local regulations.
2. Remove the shipping carton, tape, and packing material. If any are left in the
icemaker, it will not work properly.
3. Ensure all components, fasteners, and thumbscrews are securely in place
after installation.
1) Remove the panels to prevent damage when installing the icemaker. (See "B. How to
Remove Panels.")
2) Remove the package containing the accessories.
3) Remove the protective plastic film from the panels. If the icemaker is exposed to the
sun or to heat, remove the film after the icemaker cools.
4) Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade turns freely.
5) Check that the compressor is snug on all mounting pads.
6) See the nameplate on the rear panel, and check that your voltage supplied corresponds
with the voltage specified on the nameplate.
7) This icemaker can be installed on a storage bin or dispenser unit. The KMD-901MAH
requires a storage bin or dispenser unit 42" wide or wider. The KMD-901MWH and
KMD-901MRH require a storage bin or dispenser unit 30" wide or wider. If using a
storage bin with a KMD-901MAH, the recommended bin is HOSHIZAKI ICE STORAGE
BIN, Model B-700 series. With a KMD-901MWH or KMD-901MRH, the recommended
bin is HOSHIZAKI ICE STORAGE BIN, Model B-500 series.
8) On remote air-cooled models, a remote condenser unit is needed. The recommended
remote condenser unit is HOSHIZAKI REMOTE CONDENSER UNIT, Model URC-9F.
B. How to Remove Panels
See Fig. 1
• Front Panel: Remove the screw. Lift up and
towards you.
• Top Panel: Lift up at front slightly, push
rearward, and lift off.
• Side Panel (R): Remove the screw. Slide
forward slightly, and lift off.
• Insulation Panel: Remove thumbscrew, lift up
slightly, and pull towards you.
Fig. 1
Top Panel
Side
Panel (R)
Front
Panel
Insulation
Panel