HP 9304M - Manual (Page 16)

HP ProCurve Routing Switch 9308M / 9304M Reviewer’s Guide
2.7.2 Layer 3 and Layer 4 Filtering
At Layer 3 and Layer 4, these filters available are:
IP Filters IPX Filters
� Inbound and/or outbound IP addresses � Inbound and/or outbound IPX addresses
� Protocol types (UDP, TCP, etc.) � Inbound and outbound forward filters
� Port numbers or ranges of numbers (ftp, http, etc.) (Allows a remote IPX client access to a restricted-
� Specific RIP routes inbound
access server)
� Specific advertised RIP routes outbound � Specific RIP routes inbound
� RIP redistribution (conversion of OSPF routes to � Specific advertised RIP routes outbound
RIP)
� OSPF redistribution (conversion of RIP routes to
OSPF)
� Specific advertised SAP routes (128 filters max
per chassis)
AppleTalk Filters
� Zone filters - ability to filter resource access from other zones
� Network filters - Specific advertised zones in the routing packets
2.8 Flexibility
The HP ProCurve routing switches have been designed with flexibility and high port density in mind.
Any module type can be plugged into any of the module slots. The only requirement is that one, and
only one, module with management must be installed. The modules are hot swappable. Available
module types are:
•
HP ProCurve 9300 10/100 Module (24 port)
•
HP ProCurve 9300 10/100 Management Module (16 port)
•
HP ProCurve 9300 100Base-FX Module (24 port, MT-RJ connectors) MT-RJ is a new connector type
that allows full duplex 100Base-FX connections in the same space as a RJ-45 connection. Adapter
cables for SC to MT-RJ conversion are available from 3
rd party sources.
•
HP ProCurve 9300 Gigabit SX Module (8 port, SC connectors)
•
HP ProCurve 9300 Gigabit SX Management Module (8 port, SC connectors) Works with 62.5/125
multi-mode fiber cable at up to 220M, or 50/125 multi-mode fiber cable at up to 500m.
•
HP ProCurve 9300 Gigabit SX/LX Module(4 ports SX, 4 ports LX, SC connectors) SX connections
work with 62.5/125 multi-mode fiber cable at up to 220M, or 50/125 multi-mode fiber cable at up to
500m connections. LX connections work with single-mode fiber cable up to 5km, or with either
62.5/125 or 50/125 multi-mode fiber cable up to 550m (a mode-conditioning cable may be required
for multi-mode use on some older fiber-optic cables per IEEE 802.3z).
•
HP ProCurve 9300 Gigabit SX/LX Management Module (4 ports SX, 4 ports LX, SC connectors)
Same comments as for the card above.
A fully loaded HP ProCurve Routing Switch 9304M can have (88) 10/100Mbps ports or (32) Gigabit
ports in a box only 22.8cm (9") in height and 13.8kg (30.8lbs).
A fully loaded HP ProCurve Routing Switch 9308M can have (188) 10/100Mbps ports or (64) Gigabit
ports in a box only 52.7cm (20.75") in height and 26kg (57.3lbs).
©1999 Hewlett-Packard Company Revision 4.0 – 4/1/1999 Page: 16 of 27