Husqvarna 325HDA55X-Series - Manual (Page 12)

12
– English
ASSEMBLY
Fitting the hand guard and loop
handle (325HDA55/325HE3)
1. Assemble the hand guard
and loop handle by screwing
them together. Take care to
align the holes in both parts.
2. Slide the loop handle and the
hand guard onto the shaft.
3. Slide the spacer into the slot
in the loop handle.
4. Fit the nut and bolt. Do not
over-tighten.
5. Adjust to give a comfortable
working position. Tighten
the nut.
NOTE! The loop handle and
hand guard must not be
fitted behind the arrow
marked on the shaft.
Fitting the angle adjuster
(325HE3/325HE4)
1. Fit the angle adjuster
over the two holes in the
cutting attachment.
NOTE! The angle
adjuster must be fitted
on the side nearest the
shaft.
2. Fit the two washers and
short screws. Tighten the
screws.
3. Fit the long screw,
washers and knob.
Fitting the cutting attachment
Adjusting the harness (325HE4)
You should always use the
harness with the machine to
give maximum control and
reduce strain on your arms
and back.
1. Put on the harness.
2. Hook the machine
onto the hook on the
harness.
3. Adjust the length of the
harness so that the
hook is roughly level
with your right hip.
Lay the hedge trimmer on a
flat surface before fitting the
cutting attachment. Other-
wise the cutting attachment
may not be fitted straight.
1. Fit the cutting
attachment to the shaft.
NOTE! Make sure the
drive shaft on the shaft is
aligned with the cut-out
in the cutting
attachment.
2. Tighten the lower screw,
followed by the upper
screw.