HP 2800 - Manual (Page 220)

Configuring Port-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Displaying 802.1X Configuration,
Statistics, and Counters
802.1X Authentication Commands
802.1X Supplicant Commands
802.1X Open VLAN Mode Commands
802.1X-Related Show Commands
show port-access authenticator
show port-access supplicant
Details of 802.1X Mode Status Listings
RADIUS server configuration
page 8-15
page 8-34
page 8-21
below
page 8-43
page 8-40
pages 8-20
Show Commands for Port-Access Authenticator
Syntax: show port-access authenticator [[e] < port-list >]
[config | statistics | session-counters]
• Without [< port-list > [config | statistics | session-
counters]], displays whether port-access
authenticator is active (
Yes or No) and the status of
all ports configured for 802.1X authentication. The
Authenticator Backend State in this data refers to the
switch’s interaction with the authentication server.
• With < port-list > only, same as above, but limits port
status to only the specified port. Does not display
data for a specified port that is not enabled as an
authenticator.
• With [< port-list > [config | statistics | session-counters]],
displays the [config | statistics | session-counters] data
for the specified port(s). Does not display data for a
specified port that is not enabled as an authenticator.
• With [config | statistics | session-counters] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For descriptions of [config | statistics | session-counters]
refer to the next section of this table.
8-38