Need only a quick start, Ip addressing, To set up and install the switch in your network – HP 2800 User Manual
Page 23: Need only a quick start? -11
Getting Started
Need Only a Quick Start?
■
If you need further information on Hewlett-Packard switch tech
nology, visit the HP ProCurve website at:
http://www.hp.com/go/hpprocurve
Need Only a Quick Start?
IP Addressing.
If you just want to give the switch an IP address, or if you
are not using VLANs, HP recommends that you use the Switch Setup screen
to quickly configure IP addressing. To do so, do one of the following:
■
Enter
setup at the CLI Manager level prompt.
HPswitch# setup
■
In the Main Menu of the Menu interface, select
8. Run Setup
For more on using the Switch Setup screen, refer to the Installation and
Getting Started Guide
you received with the switch.
To Set Up and Install the Switch in Your
Network
Use the Installation and Getting Started Guide for your switch model
(shipped with the switch) for the following:
■
Notes, cautions, and warnings related to installing and using the
switch and its related modules
■
Instructions for physically installing the switch in your network
■
Quickly assigning an IP address and subnet mask, set a Manager
password, and (optionally) configure other basic features.
1-11