HP 2800 - Manual (Page 284)

Using Authorized IP Managers
Defining Authorized Management Stations
2. Enter an Authorized Manager IP address here.
5. Press [Enter], then [S] (for Save) to configure the
IP Authorized Manager entry.
3. Use the default mask to allow access by one
management device, or edit the mask to allow
access by a block of management devices. See
“Building IP Masks” on page 11-9.
4. Use the Space bar to select Manager or Operator
access.
Applies only to access through Telnet, SNMPv1,
and SNMPv2c. Refer to the Note on page 11-3.
Figure 11-2. Example of How To Add an Authorized Manager Entry (Continued)
Editing or Deleting an Authorized Manager Entry. Go to the IP Manag­
ers List screen (figure 11-1), highlight the desired entry, and press [E] (for Edit)
or [D] (for Delete).
CLI: Viewing and Configuring Authorized IP Managers
Authorized IP Managers Commands Used in This Section
Command Page
show ip authorized-managers below
ip authorized-managers 11-7
<ip-address> 11-8
<ip-mask-bits> 11-8
[access<operator | manager>]
Listing the Switch’s Current Authorized IP Manager(s)
Use the show ip authorized-managers command to list IP stations authorized to
access the switch. For example:
11-6