Assembly, Dismantling, Assembling the cutting equipment – Husqvarna 325RX User Manual

Page 13

Advertising
background image

English

– 13

ASSEMBLY

1151416-95 Rev. 1 2008-12-23

Assembling and dismantling the
two-piece shaft (325RDx)

Assembly

•

Loosen the coupling by turning the knob.

•

Align the tab of the attachment (A) with the arrow on the
coupling (B).

•

Push the attachment into the coupling until the attachment
snaps into place.

•

Before using the unit, tighten the knob securely.

Dismantling

•

Loosen the coupling by turning the knob (at least 3 times).

•

Push and hold the button (C). While securely holding the
engine end, pull the attachment straight out of the
coupling.

Assembling the cutting equipment

Fitting a blade guard, grass blade
and grass cutter

•

Hook the blade guard/combination guard (A) onto the
fitting on the shaft and secure with the bolt.

CAUTION! Use the recommended blade guard. See the
Technical data section.

•

Fit the drive disc (B) on the output shaft.

•

Turn the blade shaft until one of the holes in the drive disc
aligns with the corresponding hole in the gear housing.

•

Insert the locking pin (C) in the hole to lock the shaft.

A

B

C

!

WARNING!

When fitting the cutting attachment it is
extremely important that the raised section
on the drive disc/support flange engages
correctly in the centre hole of the cutting
attachment. If the cutting attachment is fitted
incorrectly it can result in serious and/or
fatal personal injury.

!

!

WARNING! Never use a cutting attachment
without an approved guard. See the chapter
on Technical data. If an incorrect or faulty
guard is fitted this can cause serious
personal injury.

IMPORTANT! If a saw blade or grass blade are to be used
the machine must be equipped with the correct handlebar,
blade guard and harness.

G

F

D

B

C

A

E

Advertising
This manual is related to the following products: