Husqvarna 390XPG - Manual (Page 39)

English – 39
TECHNICAL DATA
Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting
equipment.
Listed ATM is the Oregon designation of Armour Tip Medium hard nose bar.
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
Saw chain filing and file gauges
Bar Chain
Length, inch Pitch, inch Gauge, inch Max. nose radius Type Drive link count
18-28 3/8" 0,058 11T Husqvarna H42,
Oregon 73LP /
73LG / 73V
68-92
18-28 3/8" 0,058 ATM 1,33” 68-92
0,050"/1,3 mm - 72LP 72LG 72V
0,058"/1,5 mm H42 73LP 73LG 73V
!
WARNING! This chain saw model is capable of severe kickback that could result in serious injuries
to the user. Do not operate this saw unless you have extraordinary cutting needs and experience
and specialized training for dealing with kickback. Saws with significantly reduced kickback
potential are available. Always use the safest saw and cutting equipment applicable to your cutting
need.