Fuel filter, Air filter, Bevel gear – Husqvarna 430LS User Manual

Page 18: Maintenance

Advertising
background image

MAINTENANCE

18 – English

replaced after about a month in operation or earlier if
necessary.

CAUTION! Always use the recommended spark plug
type! Use of the wrong spark plug can damage the piston/
cylinder. Check that the spark plug is fitted with a
suppressor.

Fuel filter

When the engine runs short of fuel supply, check the fuel
cap and the fuel filter for blockage.

Air filter

The air filter must be regularly cleaned to remove dust
and dirt in order to avoid:

Carburettor malfunctions

Starting problems

Loss of engine power

Unnecessary wear to engine parts

Excessive fuel consumption.

Clean the filter every 25 hours, or more regularly if
conditions are exceptionally dusty.

An air filter that has been in use for a long time cannot be
cleaned completely. The filter must therefore be replaced
with a new one at regular intervals. A damaged air filter
must always be replaced.

Bevel gear

There is a grease nipple on the gearbox. Use a grease
gun to top up with grease. This should be carried out after
approximately every 25 working hours. Use Husqvarna
special grease.

Remove the drive disc or the side bolt in the gear cae
before installing new grease to arrange for old grease to
exit.

CAUTION! When removing and installing the drive disc,
use care not to allow any dirt and dust entering into the
gear case.

0,6 - 0,7 mm (426 LST)
0,9 - 1,0 mm (430 LS)

CAUTION! Use only HUSQVARNA replacement parts.
Use of other brands of replacement parts can cause
damage to your unit or injury to the operator or others.
Your warranty does not cover damage or liability caused
by the use of accessories and/or attachments not
specifically recommended by HUSQVARNA.

H1153174-95,426LST,430LS,US.fm Page 18 Monday, November 30, 2009 10:56 AM

Advertising
This manual is related to the following products: