Hearth and Home Technologies Firebrick Termination Cap DVP-FBHT - Manual

1
Printed in U.S.A. Copyright 2006
Hearth & Home Technologies, 20802 Kensington Boulevard, Lakeville, MN 55044
2084-900B 1/06
DVP-FBHT
Firebrick Termination Cap
- Installation Instructions -
CAUTION
Sharp Edges
• Wear protective gloves
and safety glasses
during installation.
These instructions should be used along
with the Cinch Pipe and
Termination Cap System instructions
included with this kit.
The DVP-FBHT is a horizontal firebrick termination cap with
4 inch telescoping flue (see Figure 1).
Included is the DVP-WS wall shield firestop with heat shield
and one fastener pack.
WARNING
Fire Risk
Do NOT use this termination cap on vinyl siding.
Figure 1. DVP-FBHT
WALL SHIELD
FIRESTOP
METAL
BACKPLATE
FIREBRICK
BOLT (3)
TELESCOPING
FLUE SECTION
HEAT SHIELD
Exterior finishing materials allowed ONLY above line.
1 IN.
Installation
1. Carefully remove cap from the packaging.
Note: Variation in the appearance of the termination
cap color and surface are inherent and unique
characteristics of the manufacturing process and are
to be expected with this product. Such surface
characteristics as chips, small cracks, and pits do
not affect the product performance in any manner.
2. Frame the 12 inch by 10 inch opening in the wall by
following the directions in the Cinch Pipe and Termination
cap instructions. When housewrap or underlayment is
used, the housewrap manufacturer’s instructions for
flashing a penetration MUST be followed.
3. Install the interior wall shield firestop by following the
instructions in the Cinch Pipe and Termination cap
instructions.