Heath Zenith 598-1172-02 - Manual (Page 3)

-3- 598-1172-02
Tune Settings
Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong (two note), or West-
minster (eight note) (Available on selected chimes). The factory setting is for the Ding-Dong tune
(or Westminster, when available). This tune can be changed by following the instructions below.
•
Ding (one note tune)
Push button: Add a jumper to location 8.
•
Ding-Dong (two note tune)
Push button: Remove jumper from location 8.
Chime: Remove jumper from location 8.
•
Westminster (Eight note tune) (Available on selected chimes)
Push button: Remove jumper from location 8.
Chime: Add a jumper to location 8.
Note: All models have both front and back door tune capabilities. We recommend the back door
use the
Ding tune and the front door use the Ding-Dong tune (or Westminster tune, available
on selected chimes). Models that include two push buttons will come factory set for front and
back doors. Decals on the rear of the push button will indicate its setting.
Note: Some models might require the use of
tweezers to remove and replace the jumpers.
TYPE ‘D’
LR20
TYPE ‘D’
LR20
TYPE ‘D’
LR20
1
2
3
4
5
6
7
8
VOLUME
Push Button Battery Replacement
Install an alkaline type A23 12 Volt battery. See diagram
inside push button for correct battery orientation.
Inside Push button
Front of Chime Base
Tune Setting (Not
used on all models)
Tune Setting
1
2 3
4
5 6 7 8
Chime Volume
Control
* Code Settings
1-7 Must Match
Both Push button
and Chime