Humax CR-3510 - Manual (Page 22)

21
Time Setting
You can set the Current Time and Wakeup Time in this mode.
Furthermore, the Service Number in the Wakeup Time mode and
Sleep Time (standby mode) can be set. When a VCR is connected,
recording can be automatically done according to Wakeup/Sleep
Time Setting.
To set the Current Time, enter the Offset value using the
standardized information of current service area.
The time setting will be used as the standardized time for the
I-Plate, TV Guide, Wakeup and Sleep timer.
Current time is based on TDT (Time and Data Table) at the stream
of the current service.
Select the time when STB is turned on.
Use the Number buttons(0~9) on the remote control unit to enter
your Wakeup Time.
Use the buttons to set the service number provided for the set
Wakeup Time.
Use the TV/Radio( )button on the remote control unit to toggle
TV/Radio service.
The Service Name that has been determined by the
Wakeup Service No. will be shown.
Depending on Time Setting, select the time when STB is turned off.
Current Time
Time Offset
Wakeup Time
Wakeup Service No.
Service Name
Sleep Time
Guide of Main Menu