HP 510 - Manual (Page 138)

Sheet too long
Please check it is not a roll
Press ENTER to retry
Press CANCEL to abort You have requested the printer to load a sheet of paper, but the
sheet appears to be too long.
Check that the paper is not a roll.
Either: Press the Enter key to try to load the sheet again;
Or: Press the Cancel key to stop the process. If the paper is on a
roll, follow the instructions in
Loading roll paper .
Troubleshooting finished
Resume normal printing
If problem persists select
Troubleshooting again
Press ENTER to continue The printer has finished the Troubleshooting routine and will not at
this stage perform further cleaning on the printheads because this
could damage the other ones. However, according to the evaluation
you have given, the printheads require cleaning because there are
defects in the Diagnostic Print.
Press the Enter key. Then resume your normal printing activities. If
the problem recurs, try using the Troubleshooting routine again, or
select Replace Printheads from the front panel (in the Ink System
menu) to replace the printheads that are faulty.
Troubleshooting requires
paper for a diagnostic print. The Troubleshooting utility has found that there is no paper loaded
in the printer.
Load a roll of paper.
Unable to initialize ink system.
Call HP representative. The system cannot successfully complete ink system start-up.
Call HP for service.
Unable to prepare ink system.
Open window to check
SETUP printheads During ink system start-up, the purge of the ink system has failed
and the system is asking you if the preparation has completed.
Check the setup printheads and then follow the instructions in the
front panel and respond to further questions.
Front-panel messages
Message Explanation and action