Harbor Freight Tools USGENERAL 97071 - Manual (Page 5)

Page 5 SKU 97071 For technical questions, please call 1-800-444-3353.
Mounting in concrete
Choose a location to install the Wheel Chock that is flat, level, and capable of
bearing the combined weight of the Wheel Chock and the motorcycle being se-
cured. The location should not obstruct walkways and still provide enough room
to retrieve the motorcycle after it is mounted. The surface of the location should
be one suitable for the mounting of heavy equipment.
Use the mounting holes in the Base (9) of the Stand as a template. Arrange the
Base (7) in the chosen location and, using a pencil, mark where the holes are to
be drilled.
You will need concrete anchors (not included) to secure the Base (9) to the con-
crete floor. Using the correct size concrete drill bit (not included), drill the mount-
ing holes to secure the Base (9).
Attach the concrete anchors to the floor. Secure the Base (7) to the floor utilizing
concrete anchors.
note. Do not sit on the motorcycle when it is loaded in the Wheel Chock.
truck Bed Mounting
Place the Base (9) in the desired location of the truck bed or motorcycle lift. Use
the holes in the Base as a pattern to mark where to drill the holes for the hard-
ware to mount the Stand.
Warning: Verify that the installation surface has no hidden wires, brake lines, etc. be-
fore drilling.
Use a power drill (not included) and a steel cutting drill bit (not included) to drill
holes in the truck bed or motorcycle lift.
Attach the Base (9) to the truck bed utilizing the appropriate hardware (not in-
cluded).
operating instructions
read the entire iMportant saFety inForMation section at the
beginning of this manual including all text under subheadings therein
before set up or use of this product.
Select the correct mounting hole for the motorcycle being loaded on the Stand,
and adjust the location of the Wheel Adapter (8) to fit the tire length properly.
To load a motorcycle, lower the Wheel Adapter to the horizontal position and
simply push the motorcycle into the Stand. The Wheel Adapter will close on the
motorcycle tire, securing the bike in an upright position.
1.
2.
3.
4.
1.
2.
3.
1.
2.