Haan SWIFT SI-25 - Manual (Page 11)

9
IMPORTANT: Vibration Sound
IMPORTANT
Always empty the water tank once you have finished using your
Floor Sanitizer.
7
10
Tilt handle at a 45º angle. Push
and pull slowly across the floor
to clean thoroughly.
When unit has cooled, remove
Ultra-microfiber pad. Store
unit upright in a dry area.
8
When done, push ON/OFF button.
9
Place unit with Ultra-microfi-
ber pad attached onto Floor
Protector / Resting Mat. Allow
to cool down for five (5) min.
White spot left on floor.
Unit does not emit steam.
Water left on floor.
Unit not operating.
• When cleaning do not leave unit in one spot for too long.
• Use protector pad / floor mat when unit is ON and stationary.
• Use distilled water instead of hard tap water.
NOTE: To remove spot, use a damp cloth with a few drops of white vinegar
to rub and remove stain.
• Ensure water tank is filled with water.
• Change the Ultra-microfiber pad.
• Ensure unit is always level and parallel to the floor.
• Ensure plug is set firmly in outlet.
• Replace fuse or reset breaker.
Problem Solution
Troubleshooting
During use it’s normal to hear a “clicking” sound coming from
the unit. This sound is produced by the water being pumped
through the unit.