Hotpoint CTD00 - Manual (Page 3)

3
Important Information
Impor
tant
Inf
ormation
Installation
Description
Star
t
and
Programmes
L
aundry
Warnings
and
Suggestions
Maint
enanc
e
and
C
are
Servic
e
T
roubleshooting
GB
Condenser Unit...
! You MUST clean the fluff from the condenser EVERY
month.
! Failure to clean the condenser could cause premature
failure of your dryer.
● Check that:
- The positioning arrows are pointing upwards.
- The 3 clips are re-secured back into their ‘lock’ position.
STEP 1.
Open the condenser cover
- hold the handle and
pull towards you.
STEP 2.
Remove the condenser by
rotating the 3 clips then
pulling the condenser
towards you.
(There may be some water
in the tubes, this is normal). STEP 3.
Flush the condenser, from
the rear with water, to
remove any fluff deposits. STEP 4.
Refit the condenser unit
- ensure that the unit is
pushed in fully, all 3 clips
are re-secured and the
positiong arrows on the
front of the condenser are
pointing upwards.
Rotate 3 clips