Hotpoint BE32 - Manual (Page 13)

Installation
13
Fig. 1
IMPORTANT
Minimum unobstructed depth
50mm
Worktop thickness
Preferred 30-40mm
19mm minimum
recommended
50mm
490mm
560mm
Front edge
of worktop
Fig. 2
30mm
worktop
Outside base of hob Inside base of hob
40mm
worktop
FIXING CLAMP
Note: Do not over tighten the hob clamps as distortion of the hob may occur.
FITTING THE HOB
Unpack the hob from the carton.
Remove the bag containing the sealing tape, fixing brackets and screws.
Fit the sealing tape around the edge of the cut-out in the worktop.
Lower the hob into the worktop ensuring the mains lead is fed into the base unit and is not
trapped under the flanges.
Fix the hob to the worktop using the fixing brackets and screws (see Fig 2) ensuring that the
insulating pads are fitted between the brackets and the worktop (see fig 2). The brackets can either
be hooked into the base panel slots or used to form a bridge between the panel and the worktop.
Brackets fitted in the corners can either be fitted across to the sides, front or back of the worktop.
NB Do not over tighten the hob clamps as distortion of the hob may occur.
Connect the hob to the electrical supply (see INSTALLATION).
Ensure that the hob is functioning correctly prior to use. Instruct the user in the operation of the
hob.