HP xp7010/xp7030 - Manual (Page 15)

Setting up the projector 15
Connecting power
1. Place the projector on a stable platform located 1.2 to 10 m (4 to 33 ft) in front of the
screen. Ideally, the platform should be lower than the bottom of the screen.
2. Connect one end of the power cord to the back of the projector 1 and the other end to a
grounded electrical outlet 2 .
3. Turn on the disconnect switch 3 on the side of the projector.
If you want to permanently install the projector on the ceiling or behind the screen, see
“Installing the projector” on page 44.