Engine oil change, Air cleaner service, Air cleaner (p. 12) – HONDA HRR216VKA User Manual

Page 12

Advertising
background image

12

Engine Oil Change

Drain the used oil while the engine is warm. Warm oil drains quickly
and completely.

1. Turn the fuel valve OFF. This will reduce the possibility of fuel

leakage.

2. Wipe the oil filler area clean, then remove the oil filler cap/dipstick.

3. Place a suitable

container next to the
mower to catch the
used oil, then tilt the
mower on its right
side.

The used oil will drain
through the filler neck.
Allow the oil to drain
completely.

Please dispose of used motor oil and the containers in a manner
that is compatible with the environment. We suggest you take it in
a sealed container to your local recycling center or service station
for reclamation. Do not throw it in the trash, pour it on the ground,
or pour it down a drain.

4. Fill with the recommended oil. Do

not overfill. Allow a couple of
minutes for the oil to settle in the
engine, then measure the oil level.

NOTICE

Using nondetergent oil can
shorten the engine’s service life,
and using 2-stroke oil can damage
the engine.

Air Cleaner Service

A dirty air cleaner will restrict air flow to the carburetor, reducing
engine performance. If you operate the mower in very dusty areas,
clean the air cleaner more often than specified in the MAINTENANCE
SCHEDULE
(page 9).

NOTICE

Operating the engine without an air cleaner, or with a damaged air
cleaner, will allow dirt to enter the engine, causing rapid engine wear.
This type of damage is not covered by the
DISTRIBUTOR’S LIMITED
WARRANTY (page 20).

1. Press down on the cover tabs and remove the cover.

2. Remove the filter from the air cleaner housing.

3. Inspect the filter; replace if damaged.

4. Clean the filter by tapping it several times on a hard surface to

remove dirt, or blow compressed air (not exceeding 30 psi
[207 kPa]) through the air filter from the inside. Never try to brush
off dirt; brushing will force dirt into the fibers.

5. Wipe dirt from the inside of the air cleaner housing and cover,

using a moist rag. Be careful to prevent dirt from entering the air
duct that leads to the carburetor.

6. Reinstall the filter and cover.

AIR CLEANER
HOUSING

FILTER

COVER

COVER TABS

AIR DUCT

Advertising
This manual is related to the following products: