Healthrider 831.287940 - Manual (Page 7)

7
8. Insert the Seat (17) into the Weight Saddle (34).
Slide the Large Washer (19) onto the Seat Bolt
(51). Tighten the Seat Knob (18) onto the Seat Bolt
until the Washer is secure against the Seat Frame
(48).
9. Insert the Weight Bar (32) through the Weight
Saddle (34). Center the Weight Bar in the Weight
Saddle. Thread the Weight Bar Screw (54) fully into
the drilled hole in the Weight Saddle to secure the
Weight Bar.
Slide a Weight Clip (1) onto each side of the Weight
Bar.
10. Press the Magnet w/Bracket (13) onto the Pedal
Frame (30) as shown.
Slide the Monitor (6) fully onto the Main Frame (47)
as shown in inset drawing A. Press down on the
Monitor as shown in inset drawing B until it snaps
into place.
11. Remove the battery cover from the Monitor (6).
Insert a new AAA battery into the Monitor. Identify
the negative (–) and positive (+) ends of the battery.
The spring in the battery compartment should touch
the negative end of the battery.
8
48
34
17
51
18
34
32
1
54
1
19
9
10
11
6
47
13
30
6
(–) (+)
Battery
Cover
AAA
Battery
A
B