Humminbird AS WX 1 - Manual (Page 48)

F Fiissh hiin ng g S Syysstte em m D Do oe essn n’’tt P Po ow we err U Up p
If your Fishing System doesn’t power up, use the installation guide that is
included with your Fishing System to confirm specific details, making sure that:
• the power cable is properly connected to the Fishing System control
head,
• the power cable is wired correctly, with red to positive battery
terminal and black to negative terminal or ground,
• the fuse is operational, and
• the battery voltage of the power connector is at least 10 Volts.
Correct any known problems, including removing corrosion from the battery
terminals or wiring, or actually replacing the battery if necessary.
F Fiissh hiin ng g S Syysstte em m D De effa au ullttss tto o S Siim mu ulla atto orr
w wiitth h a a T Trra an nssd du uc ce err A Atttta ac ch he ed d
A connected and functioning transducer will cause the newly-started Fishing
System to go into Normal operating mode automatically. If, when you power
up the Fishing System, it goes into Simulator mode automatically, even
though a transducer is already connected, this means that the control head
is not detecting the transducer. Perform the following troubleshooting tasks:
• Using the Installation Guide that also comes with your Fishing
System, check to make sure that the transducer cable is securely
connected to the Fishing System. Reconnect if necessary, and power
up the Fishing System again to see if this fixes the problem.
• Replace the non-functioning transducer with a known good
transducer if available and power up the control head again.
• Check the transducer cable. Replace the transducer if the cable is
damaged or corroded.
42 Troubleshooting