Harbor Freight Tools Drillmaster 18V Cordless Drill 68239 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. SKU 68239
7. To reduce vibration, maintain the tool as
explained in this manual. If any abnormal
vibration occurs, stop use immediately.
SAVE THESE
INSTRUCTIONS.
Grounding
TO PREVENT ELECTRIC SHOCK AND
DEATH FROM INCORRECT GROUNDING
WIRE CONNECTION: Check with a qualified
electrician if you are in doubt as to whether
the outlet is properly grounded. Do not modify the
power cord plug provided with the charger. Never
remove the grounding prong from the plug. Do not use
the charger if the power cord or plug is damaged.
If damaged, have it repaired by a service facility before
use. If the plug will not fit the outlet, have a proper
outlet installed by a qualified electrician.
Double Insulated Tools:
Tools with Two Prong Plugs
Outlets for 2-Prong Plug
1. Tools marked “Double Insulated” do not require
grounding. They have a special double insulation
system which satisfies OSHA requirements and
complies with the applicable standards of Underwriters
Laboratories, Inc., the Canadian Standard
Association, and the National Electrical Code.
2. Double insulated tools may be used in either of the 120
volt outlets shown in the preceding illustration.
(See Outlets for 2-Prong Plug.)
Extension Cords
Note: Extension cords must not be used with this
item’s charger.
Symbology
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n0 xxxx/min. No Load Revolutions per Minute (RPM)
WARNING marking concerning Risk
of Eye Injury. Wear ANSI-approved
safety goggles with side shields.
Read the manual before
set-up and/or use.
WARNING marking concerning Risk
of Fire.
Do not cover ventilation ducts.
Keep flammable objects away.
WARNING marking concerning Risk of
Electric Shock.
Properly connect charger power
cord to appropriate outlet.